Excess Crystal Clay Bits – Make a Beaded Drop!

This is one of my newest ways that I’ve started to use my excess Crystal Clay. It is also a great way to use up excess snips of ball chain that you might have on hand.

Be Inspired!

_DSC8126-logo _DSC8128-2-logo

Learn How!

Materials needed:


Step 1:
Follow the manufacturer’s instructions for the handling and mixing of the Crystal Clay. While wearing gloves, pinch off two equal sized balls of Part A and Part B and blend together fully until the clay is no longer marbled and uniform in color. You have approximately 90-120 minutes of working time before the clay starts to harden, so take your time. Once the clay is thoroughly mixed, remove your gloves to make it easier to work with the clay.

Step 2:
Pinch off a small ball of the clay and roll it in the palm of your hands until smooth and round. Any creases in the clay will be more challenging to smooth out later, so roll until it is nice and smooth.


Step 3:
Poke the end of the headpin into the ball of Crystal Clay.  Use your fingers to gently sculpt a drop like shape around the headpin.


Step 4:
Starting at the bottom end of the drop, embed a Bead Cap 6mm Petal. This provides a nice base to the drop.


Step 5:
Now you are ready to start to wrap the ball chain around the drop and embedding the chain into the Crystal Clay. Wrap the chain around the Crystal Clay drop pressing the ball chain lightly into the clay. This can be tricky at first because the tendency is to press too hard and this will make the chain and drop all wonky.

DSC_0597_1000x1000 DSC_0599_1000x1000 DSC_0615_1000x1000

Step 6:
When you arrive at the top of the Crystal Clay drop, use your flush cutters to cut off the excess ball chain. Use your fingers to gently embed the ball chain into the Crystal Clay and to shape the drop.


Step 7:
Thread on beadcaps of your choice to the top of your beaded drop and let dry until set (a couple hours).  


Step 8:
I added one small link of the ball chain into the center of the beadcap to provide an extra accent.

DSC_0637_1000x1000 DSC_0643_1000x1000 DSC_0645_1000x1000

Step 9:
Once the drop is hard, use your needle nose pliers to create a loop from the headpin.

This is part of a series of tips and tutorials on using excess Crystal Clay bits. Make sure to check the blog for the other tips!

If you enjoyed reading this post, please subscribe to our blog. Here are 10 Reasons Why to Subscribe and a place to do so!

Leave a Reply

Your email address will not be published. Required fields are marked *

0 WooCommerce Floating Cart

No products in the cart.